Crews are having to wait to raise the device that failed to stop oil from spewing into the Gulf of Mexico.
Darin Hilton, the captain of the Helix Q4000 vessel that's lifting the 300-ton blowout preventer to the surface, said Saturday that hydrates have built up on the contraption. Crews have to wait for the hydrates to melt before the device can be lifted the final 500 feet to the surface.
BP spokesman Neil Chapman says the device likely won't reach the deck until around 7 p.m. EDT.
The blowout preventer is considered a key piece of evidence in the investigation into the oil spill. FBI agents are on board the vessel to take possession of the device once it's on board.
Once it is lifted, the device will be loaded onto a barge and taken for analysis at a NASA facility in Michoud, La.
THIS IS A BREAKING NEWS UPDATE. Check back soon for further information. AP's earlier story is below.
NEW ORLEANS (AP) — BP crews worked Saturday to slowly raise the 300-ton blowout preventer that failed to stop oil from spewing into the Gulf of Mexico, careful not to damage or drop a key piece of evidence in the spill investigation.
When the blowout preventer reaches the surface after its mile-long journey, government investigators will take possession of it and eventually examine it, hoping to gain insight into why the device failed.
A BP PLC spokesman said in an e-mail to The Associated Press that the 50-foot device was detached from the wellhead Friday afternoon. Another blowout preventer had successfully been placed on the blown-out well, the government said later.
The April 20 explosion aboard the Deepwater Horizon killed 11 workers and led to 206 million gallons of oil spewing from BP's undersea well.
Investigators know the explosion was triggered by a bubble of methane gas that escaped from the well and shot up the drill column, expanding quickly as it burst through several seals and barriers before igniting.
But they don't know exactly how or why the gas escaped. And they don't know why the blowout preventer didn't seal the well pipe at the sea bottom after the eruption, as it was supposed to. While the device didn't close — or may have closed partially — hearings have produced no clear picture of why it didn't plug the well.
Lawyers will be watching closely, as hundreds of lawsuits have been filed over the oil spill. Future liabilities faced by a number of corporations could be riding on what the analysis of the blowout preventer shows.
The raising of the blowout preventer followed Thursday's removal of a temporary cap that stopped oil from gushing into the Gulf in mid-July. No more oil was expected to leak into the sea, but crews were standing by with collection vessels just in case.
The government wanted to replace the failed blowout preventer first to deal with any pressure that is caused when a relief well BP has been drilling intersects the blown-out well.
Once that intersection occurs sometime after Labor Day, BP is expected to use mud and cement to plug the blown-out well for good from the bottom.
© Copyright 2013 The Associated Press. All rights reserved. This material may not be published, broadcast, rewritten or redistributed.